How is the multiplication of shoots Science - Read useful advice
Read online in category: different tips and useful tips on this subject
Rooting of shoots or parts of stems - the easiest and most common method of plant propagation. The easiest way to root sprouts in a jar of water, this method can be used with respect to virtually all plants, even capricious. Nevertheless, there are certain differences which should vary depending on the type of plant rooting.
Not all plants tolerate change of water in which there are shoots on rooting. Apparently, sometimes in the water accumulate the necessary metabolic products. Poor suffer replace rooting water shoots passion fruit, as a result, they may even die. It is desirable as it evaporates the water to refill them.
Some sprouts matter and the amount of water in the pot. For example, the honeysuckle bank not give 200 ml of the roots if there is more than 3 cuttings for rooting it needs space. Of great importance is the level of water in the pot. In order to escape formed roots, need oxygen present in water, and the roots are formed only at the interface of water and air. In deep tanks insufficient oxygen at the bottom, and this often leads to decay of the shoots.
Any method of reproduction in which cuttings are stuck in a potato tuber with a pre-remote eyes. Tuber while buried in the ground and covered jar escape and regularly watered.
Rooting part of the shoot
Reproduction of part of the shoot, or layering, is the formation of a new plant on the shoots, are not separated from the mother plant.
An interesting way of reproduction - air layering, but it is applicable to a small number of plants. To start with the length determined by the future of the plant and choose the appropriate place to escape. At this point, an escape is released from the leaves and along the stem is a few notches in the same place. On the incised places impose soil or moss, and the outside is wrapped in geotextile or simple polyethylene to start rooting.
Instead, the film looks interesting small pot, as it were, put on to escape. Pot for this is sawn into two pieces, and the bottom of the hole is equal to the diameter of the escape. They put the two halves of escape and secured by placing inside the same moss or soil, not forgetting to regularly moisten the substrate. When escaping root, the stem of the mother plant is cut at the bottom of the pot.
Horizontal layers - it shoots, laid on the ground and fixed to it in 2-3 places, sprinkled on top of the ground. After rooting and separated from the parent plant.
On this page in category different tips you can read How is the multiplication of shoots Science , you free posted 7-01-2016, 06:54 our journalist admin, in any case, don't forget to share a link to useful advice this page from the "different tips" with your friends. We are a relevant and interesting life tips on various topics and they are intended for all categories of citizens, of all ages and varied professions. Now you will know How is the multiplication of shoots Science. Learn much, learn to become better and become a smart man with Bolshoi knowledge base!
Useful and interesting articles on the website all-best-tips.com
We have created a website to expand your horizons. We recommend you to read on the site our helpful hints.
Attention! Run to us more often, we constantly have new, useful articles.
Information taken from the Internet for your convenience by category razlozhenny a lot of tips and answers to frequently asked questions, which we set in daily life you will learn lots of useful information, read the answers to the questions: when? why? what? where? how?